|
|
Product Details:
Payment & Shipping Terms:
|
Specificity: | 100% |
---|
One-Step LH Ovulation Rapid Test Urine
One Step LH Urine Ovulation Test is fast and easy-to-use. It is a qualitative test that can predict when there is a LH (luteinizing hormone) surge, and in turn, when you are likely to ovulate and conceive. The tests are available in 3 different formats:
1. STRIP
2. CASSETTE
3. MIDSTREAM
The format applications range from professional to domestic usage.
WHEN TO BEGIN TESTING
First, you must determine the length of your menstrual cycle. This is the number of days from the first day of your menstrual bleeding to the day before your next bleeding begins again. Please refer to the chart below to determine when you should start testing. If your cycle is shorter than 21 days or longer than 38 days, consult your doctor. If you do not know your cycle length, you may begin the test 11 days after your first period since the average cycle length is 28 days. Perform 1 test each day over a 5 day period or until the LH surge has been detected.
URINE COLLECTION
1. Do not use first morning urine samples as LH is synthesized in your body early in the morning. It will not show up in your urine until later in the day.
2. The best time to collect your urine is between 10am - 8pm.
3. Collect urine at about the same time each day.
4. Reduce liquid intake about 2 hours before collecting your urine as a diluted urine sample can prevent the test from detecting LH surge.
STEP 1
Bring the test pouch to room temperature (18-30°C). To begin testing, open the sealed pouch by tearing along the notch. Remove the test from the pouch.
STEP 2 (TEST FORMATS)
STRIP TEST Immerse the strip into the urine with the arrow end pointing towards the urine. Do not immerse past the "Mark" line. Take the strip out after 20seconds and lay the strip flat on a clean, dry, non-absorbent surface (e.g., mouth of the urine container).
|
CASSETTE TEST Draw the urine sample into the provided pipette, and dispense 0.2ml (about 4 drops) into the round dropping well of the cassette.
|
MIDSTREAM TEST Hold the round end of cover with one hand. Use the other hand to pull out the test device and expose the absorbent window. Point the absorbent tip downward; place the absorbent tip in urine stream for at least 10 seconds to be thoroughly wet. Otherwise, you can collect your urine into a clean cup and dip half of the absorbent pad into the urine for at least 10 seconds. Re-cap the device and place it on the clean, flat surface. STEP 3 Wait for colored bands to appear. Depending on the concentration of LH in the test specimen, positive results may be observed in as short as 40 seconds. However, to confirm negative results, the complete reaction time (10 minutes) is required. Do not read results after 30 minutes.
|
Contact Person: Ms. Anna Lee
Tel: +86-755-89589611
Fax: 86-755-89580096